I have not done it on my chevrolet Tahoe, but on my 1989 ford bronco, i
used
a small grinder to grind a larger hole in the metal door panel so i could
simply undo the bolts anf remove the motor through the hole. had to do it
later on both doors and it was easy.
now i can access the motors in minutes.
old john
Hello, Shelldigger!
You wrote on Mon, 21 Apr 2008 14:43:44 -0700 (PDT):
S> There is a hole there I can just barley squeeze my arm through, I can
S> feel the motor down there, just cant figure out how to get the dang
S> thing out so I can put the new one in. There are 2 nuts up high and 2
S> bolts down low from the outer part of the door but taking them off
S> does not seem to loosen the motor in any way. (I have the door panel
S> off and checked the switch, it is good so Im pretty sure its the
S> motor) It is still attatched to the gear drive somehow, but I cant
S> find out where. Any help would be greatly appreciated.
With best regards, ajeeperman@[EMAIL PROTECTED]
E-mail: ajeeperman@[EMAIL PROTECTED]
|
