by <ajeeperman@[EMAIL PROTECTED]
>
Apr 21, 2008 at 09:41 PM
use the ohm meter part of your multimeter and check for contnuity and
amount
of resistance measured
should be in the low ohms range??
old john
Hello, blazerbrat1967!
You wrote on Mon, 21 Apr 2008 06:22:29 GMT:
b> I just took it out, and then realized after directly putting power to
b> it that the motor still worked, but before this it did not.
b> How do i check the resistor?
With best regards, ajeeperman@[EMAIL PROTECTED]
E-mail: ajeeperman@[EMAIL PROTECTED]
