by "Steve W." <csr684NOT@[EMAIL PROTECTED]
>
Apr 23, 2008 at 04:36 PM
Shelldigger wrote:
> Am I really going to have to take a grinder
> to the door and cut out a section to get the old motor out and a new
> one in....or is there a little known tip, secret, technique to to do
> this? Ill tell you right now the Haynes manual I have is worthless on
> many accounts, but especially here. They dedicate 1 paragraph to
> power
> windows, and none of it explains how or where to do a damn thing.
>
> There is a carpet panel I can pull that is close to the window motor.
> I
> suppose I can take a grinder and cut the door out so the panel will
> cover it
> once I get the motor traded out....it just seems ridiculous to have to
> do
> that though.
>
>
The motor and lift linkage come out as one piece. You need to pull the
entire inner door panel off. Then the linkage and motor can come out the
bottom access in the door. Under the plastic panel you will find the
dust/water ****eld that also gets pulled off. (looks like stiff paper
with a bead of sealer around the edge). No need to cut extra holes.
--
Steve W.
