As i said before, no you can tear the door apart, but it is much easier to
just grind a nide hole out with a cutoff disk. then it ia easy.
old john
This is for door panels, i do not know about tailgate door.
old john
Hello, Shelldigger!
You wrote on Wed, 23 Apr 2008 06:53:55 -0700 (PDT):
S> On Apr 21, 7:31 pm, "Steve W." <csr684...@[EMAIL PROTECTED]
> wrote:
??>> Shelldigger wrote:
??>>> It just so happens I am working on my Blazer windows. (Full Size)
The
??>>> rear window motor itself is I assume a reversable motor that works
??>>> via a positive line, and a body ground and a two way switch. My
??>>> window will go down but not up. At first I thought it might be the
??>>> motor, but decided to check the switch signal, and it was working
on
??>>> one side, the down side. So I figured to arc the hot side to the
dead
??>>> side and the window went up. So....Im wiring in a switch in a few
??>>> minutes. The Zone could not get me a replacement, probably should
??>>> call a dealer, but I always have to be sitting down when they qoute
??>>> me a price, so Ill just wire in another switch, and be done with
it.
??>>> This aint no Friday night going to town truck, it pulls a boat to
get
??>>> me to work.
??>>
??>>> Also having a bitch of a time with a door window motor. See my
??>>> preceding post.
??>>
??>> Yep, Basically the same motor used on the power windows. Not fun to
??>> work on some of them due to limited room.
??>>
??>> --
??>> Steve W.
??>> Near Cooperstown, New York- Hide quoted text -
??>>
??>> - Show quoted text -
With best regards, ajeeperman@[EMAIL PROTECTED]
E-mail: ajeeperman@[EMAIL PROTECTED]
|
