On Sat, 26 Apr 2008 05:01:52 -0700 (PDT), Shelldigger
<lilc01f@[EMAIL PROTECTED]
>
wrote:
>Well whadayaknow. After grinding a hole roughly 8.75x3.5 inches in the
>door, it was easy as pie.
>3 bolts and the motor dropped right out. The replacement wasnt exactly
>"bolt on" but was able to sort out what needed doing and get it
>mounted.
>
>Tip, if you have to do this, taking the time needed to file down the
>hole perimeter, while time consuming and a sweaty job, is well worth
>not having you arm sliced to pieces.
>
>Thanks much for the advice guys!
>
Being lazy, I seem to remember cutting the hole and then putting masking
tape on
the edges instead of running the sanding wheel over 'em..
mac
Please remove splinters before emailing
|
