many thanks dt.... I am going to try it over the next few weeks,, I
will let you know of my success. Pete :D
"daytripper" wrote:
> On Sun, 20 Apr 2008 03:23:32 GMT, mrpete <none@[EMAIL PROTECTED]
> wrote:
>
> >Can anyone tell me how to remove the rear door panel of a
> 2001 audi
> >A4? :?:
>
> - if you can, fully lower the window (not necessary, but makes
> the task a
> little easier)
>
> - if you have crank-style windows: you need to pry off the
> crank handle trim
> first. stick the blade of a flat-head screwdriver under the
> crank handle knob
> and lever the screwdriver to slide the crank handle trim
> towards the crank
> handle pivot. this will then expose the bolt holding the crank
> handle and
> underlying trim piece (that surrounds the crank shaft hole) to
> the window
> actuator so you can remove the bolt, crank handle and trim
> piece.
>
> - look at the arm rest, you should see a small insert near the
> hand grip.
> there is a small screw holding that insert to the arm rest.
> remove that screw,
> then pull the insert downward to remove it from the arm rest.
>
> - in the cavity exposed by removing the insert, you'll find
> one screw.
> remove it.
>
> - with the door swung open, at the aft end of the door you
> will find two
> screws, one at the top and one at the bottom, holding the door
> panel to the
> frame. Remove those two screws.
>
> - Now you should be able to life the door trim straight up and
> off the (7)
> "detent" clips.
>
> - At this point you can unclip the Bowden cable (that actuates
> the door latch)
> and disconnect it from the latch assembly. You can also
> disconnect the window
> regulator (if you have electric lifts) at the switch assembly.
>
> Cheers
>
> /daytripper
> '00 s4 6spd
|
