In article <4f9b9b9e7adave@[EMAIL PROTECTED]
>,
Dave Plowman (News) <dave@[EMAIL PROTECTED]
> wrote:
>In article <fvpn7a$qae$1@[EMAIL PROTECTED]
>,
> Scott Dorsey <kludge@[EMAIL PROTECTED]
> wrote:
>> In article <4f9b22cd56dave@[EMAIL PROTECTED]
>,
>> Dave Plowman (News) <dave@[EMAIL PROTECTED]
> wrote:
>> >In article <i%sTj.2920$0L.1118@[EMAIL PROTECTED]
>,
>> > PDO <philost@[EMAIL PROTECTED]
> wrote:
>> >> Anyone know how to check if the amplifier is working properly in an
E32
>> >> amp? I have a severe problem with balance and I think it may be the
>> >> amp. The right side is overwealming the left - in fact, at minimum
>> >> volume I cant hear the left at all and the right side is very loud.
>> >
>> >If you can't turn the volume right down on one channel and it's a
setup
>> >with separate amp I'd say the first place to look is the head unit.
>
>> And the cables.
>
>> Jumper both channels together before the amp... if the signal comes up
on
>> the bad channel, it's the head amp or the cabling at the head amp. If
it
>> doesn't, it's the amp or the speakers or the wiring between them.
>
>Or simply swap left to right. Trouble is this can be tricky with some
amps.
Right, the problem is that all the signals are on a multipin connector, so
the easiest thing to do is to jam a jumper wire into the back of the
connector.
Note that the multipin connectors _do_ fail. Not too often, but it
happens.
When you have the one in the trunk apart, pack it with dielectric grease
just
to keep it reliable in the future.
--scott
--
"C'est un Nagra. C'est suisse, et tres, tres precis."
|
