On Feb 19, 7:47=A0pm, "I'mlost" <Big...@[EMAIL PROTECTED]
> wrote:
> On Feb 18, 10:44=A0pm, Certainly <gStace...@[EMAIL PROTECTED]
> wrote:
>
>
>
>
>
> > On Feb 17, 6:51=A0pm, "I'mlost" <Big...@[EMAIL PROTECTED]
> wrote:
>
> > > On Feb 17, 9:11=A0pm, "Don Schmidt" <Don Engin...@[EMAIL PROTECTED]
>
> > > wrote:
>
> > > > Maybe ready for a new thermostat.
> > > > Crankcase oil foamy?
> > > > Moisture coming from the tail pipe?
>
> > > > --
> > > > Don
> > > > Vancouver, USA
>
> > > > "I'mlost" <Big...@[EMAIL PROTECTED]
> wrote in message
>
> > >
>news:543146aa-60fd-4da2-87e0-404e391958ec@[EMAIL PROTECTED]
>
> > > > > About every 1000 miles I have to add coolant to the system.
=A0Che=
cked
> > > > > all hoses and around water pump, no leaks that I can find. =A0
No =
excess
> > > > > water collecting under car. Any suggestions.- Hide quoted text -
>
> > > > - Show quoted text -
>
> > > No foamy oil (water in oil), =A0 Have not noticed any water from
> > > exhaust. =A0Temp. has been fluctuating for a while now. goes up to
223=
> > > when air is off and second fan comes on it cools down to around 200%
> > > Thanks Don.- Hide quoted text -
>
> > > - Show quoted text -
>
> > Check for dexcool crust around the water pump housing(crossover) at
> > the junctions with the head and block on both ends. They are a bit
> > hard to view, but can be seen. My other recommendation would be a
> > block test, these engines tend to loosen at the head gaskets due to
> > thread failure in the block. Any cold misfiring at startup?- Hide
quoted=
text -
>
> > - Show quoted text -
>
> I'm not sure what dexcool crust is but will take a look when the rain
> stops. =A0Not sure how to do a block test ether. not having any
> misfiring that is noticeable. =A0I did change the radiator cap today to
> a 16 lb. cap. that is what is called for in the manual. It had a 14
> lb. cap and it was weak. =A0I did mix the anti freeze with out realizing
> it. =A0I have red (five year) and put in about a quart of the green,
> (three year). they should not be mixed, could that have anything to do
> with it loosing water?- Hide quoted text -
>
> - Show quoted text -
Dexcool crust is just dried orange coolant residue, The block tester
is a special tool, available at NAPA or other sources. It is filled to
a predetermined level with a special fluid and placed over the
radiator opening(some fluid may need to be removed to prevent sucking
up coolant). Air is drawn through the fluid with a bulb that is
included, or positive cooling system pressure, and the fluid reacts
with the presence of combustion gases and changes colors. The fluid is
usually blue, changes from green to yellow determined by the severity
of the internal leakage. The mixing of the green into the long life
should not contribute to any fluid loss, the fluid is either leaking,
or being consumed internally. My feeling at this point is, if you
don't see any external leaks, you might consult someone and tell them
you just want a block test. It can also be done with an exhaust gas
analyzer held at the radiator opening.
|
