It should have been in the kit!
I've done hundreds of those carbs. You can go to an auto parts stores, and
ask them if they have an assortment of Nitrile O-Rings. Usually green or
blue.
The black ones won't work well, as the gas softens them up. The black ones
in the kit are made of Viton Rubber, the assortments are usually a cheap
grade rubber.
I hope this helps.
RK
"loadhawg" <loadhawg@[EMAIL PROTECTED]
> wrote in message
news:e2248833-27a4-4e7b-9f9b-c0d7f5d220f7@[EMAIL PROTECTED]
> This is for a Rochester VaraJet E2SE (Not a QJet) # 17086432 in a 1984
> GM 2.8L V6 (FBody). The carb # specific rebuild kit did not include
> one (nor did other kits I looked at).
>
> I'm looking for a replacement rubber seal that goes on the bottom of
> the Mixture Control Solenoid (down in float bowl). Mine is shot but my
> solenoid is otherwise perfectly OK.
>
> Appreciate any suggestions on where I might source one of these rubber
> seals. I'm toying with the idea of stacking some rubber o-rings or
> maybe something out of a plumbing/faucet application. Local major
> parts stores (AZone, NAPA, etc.) don't offer the seal.
>
> You can see the black rubber seal on the end in the images below...
>
> Thanks
>
> http://farm3.static.flickr.com/2183/2129538797_982f2a5fa1.jpg
>
> http://farm3.static.flickr.com/2314/2130316464_47927ff05d.jpg
