babydevil1717 wrote:
>I just bought this car, got completely screwed over, but anyway, it was
>running really rough and the check engin light was on, so i went to
>autozone and they said every senser in the car was bad, not possiable it
>wouldnt run, so i took it to a car guy he says its miss fireing, to
>replace the plugs and wires...did that 3 were fowled out, made it run a
>little better...it still idels rough and runs really lean on fuel..it
>doesnt have as much power as it should at all!! someone help im going out
>of my mind!!
on every sensor there is a 5 volt reference wire on all gm products this 5
volt reference is wired in SIERIES witch means that if there's a break in
the
circuit at that break and beyond nothing will have its 5 volt reference.
In short strip the loom off of the wireing harness at the top of the
engine,
then find your 5 volt ref. wire look for a spot in the harness where a lot
of
same color wires join together and become only one wire and this wire
comes
from the e.c.m. (I have found many similar problems like yours like this.)
--
G. Ratliff
|
