Re: Air conditioner fan only runs at full speed

"News account" <news@[EMAIL PROTECTED]
> wrote in message
news:3K-dnR00NYlqBrjbnZ2dnUVZ_t-mnZ2d@[EMAIL PROTECTED]
> I removed the glove compartment door and the cardboard cover under the
fan
> but I could not locate the resistor pack.
> The air bag was on top of the glove compartment, the fan to the right on
the
> back and the eva****ator to the left, traced several wires but no
resistor
> pack uder any of these parts. Could you please describe it?
> Thank you again.
> Ed
>


You dont need to remove the glove box. You may have to drop the lower
plastic insulator to see it. there will be 2 connectors, one connector has
a
green and a black wire in it. If you go out and purchase the resisitor you
will see what you are looking for. You may have to modify the heater box
for
the updated resistor if you purchase it from the dealer.

Glenn Beasley
Chrysler Tech
>
> "jcr" <nospam@[EMAIL PROTECTED]
> wrote in message
> news:yIadnaXGDJqhp7jbnZ2dnUVZ_vadnZ2d@[EMAIL PROTECTED]
> > Art McClinton wrote:
> >> It is the resister block that controls the fan.  You can pick one up
for
> >> about $30 from the dealer and put it in.  It is located under the
glove
> >> compartment.  Mine was replaced once under warranty and once at 80K
by
an
> >> independent.
> >> "News account" <news@[EMAIL PROTECTED]
> wrote in message
> >> news:YtidnW0qttR3477bnZ2dnUVZ_qWvnZ2d@[EMAIL PROTECTED]
> >>> My 2002 Sebring LSI air conditioner fan seems to run the fan only at
> >>> full speed, none of the other settings on the dial work. It does not
> >>> seem to be a problem with the dial. Just started about a week ago.
> >>> You have been very helpful with problems in the past, does anybody
have
> >>> any suggestions?
> >>> Thank you very much.
> >>> Ed
> >>
> >>
> > I don't remember these resistor blocks failing so frequently in years
past
> > (if at all).  So why are they now?
>