Re: My th400 pan gasket leaks, how do I stop it?

On Mon, 3 Dec 2007 14:21:31 -0600, "-the HoSt-" <Host@[EMAIL PROTECTED]
>
wrote:

>Well it IS a chrome pan, Marsh Monster mentioned that. And the holes aint
>puckered.
>I have a Haynes manual and it says 10, I do have a inch pound wrench and
I
>get it to 120 inch pounds actually. I have never gone crazy on it and
tried
>to torque it down to 30 foot pounds.
>If I seal it up and fill it up, it does not leak. If I go for a drive,
get
>the fluid hot, check the fluid level to make sure it is just right then
park
>it, it still does not appear to leak for quite some time.
>But the next morning... %&$*ing leaks.
>I figure if it were a leak somewhere else it would be evident soon after
>driving and bringing it up to temp then parking it, but it waits about 6
to
>8 hours.

Q: to the bolts that show leakage go through the casting? (Are the
holes openended?)