klutz wrote:
> "Charles Halliman" <challiman@[EMAIL PROTECTED]
> wrote in message
>
news:ad78085b-2489-440e-b5b7-3564ad54aa39@[EMAIL PROTECTED]
>> I just installed a new temperature gauge in my '69 vette. To test the
>> gauge, I tried to start my car. The engine turned over about three
>> times, without starting. This is not unusual since the car has been
>> setting up for almost two weeks. However, when I turned the ignition
>> key again, I got nothing. Even my interior lights didn't come on. The
>> clock wasn't working. Nothing was working.
>>
>> My battery was low. So, I recharged the battery. However, I still get
>> no current in the car. No fuse appears to be blown. And nothing seemed
>> to be burning. Does anyone have any ideas as to what my problem is?
>>
>> Thanks,
>> Charles
>
> Check the quality of the connection where the negative battery cable
> attaches to the frame. Corrosion will give the exact symptom you're
> describing.
>
>
I concur, check/clean the battery cable connections at both ends, and also
check/wiggle the main cable connector(s) on the firewall where the cables
connect into the body... not sure exactly where that is on a C3, on a C2
there are 2 large engine-side cables that plug into receptacles near
where the
steering column goes through the firewall. If the negative battery cable
is
attached to the frame, make sure the engine has an intact ground cable to
the frame also.
|
