Re: rear turn and stop bulb quit working

The brake and turn lights both are out on the left side, and both work on 
the right side, and both front turn signals work.
I have a factory manual on CD, but I haven't found anything in it to show 
the physical locations of junctions, etc.  Maybe I'm looking in the wrong 
places?
Bill



"Bob AZ" <rwatson767@[EMAIL PROTECTED]
> wrote in message 
news:3977220c-dbbb-4780-9b15-e793bc588835@[EMAIL PROTECTED]
> I was looking on a schematic and they show a multifunction switch. ? Is
> there a way this switch could fail and affect just one rear side?
> What is the location of the switch?
> Thanks,

Bill

Switch is in the steering wheel area. I believe you will have to
remove the steering wheel.

BUT first check the brake lights with the directional switch in the
middle or off position to make sure both the brake lights do indeed
work. This should eliminate the actual bulb and wiring.

If the brake lights do work properly try the following. With the
ignition off, switch the directional lights to both directions and be
sure the brake light goes off on the side you have switched the
directional lights to.

If you do remove the multifunction switch and replace it. Buy two
since you will eventually need another and it will be more expensive
now then later.

I have a 2001 Dodge 1500 Ram.

Bob  AZ