"Larry D. Cosby" <lcosby at knology dot net> wrote in message
news:e3aae$4784343d$4501250d$22002@[EMAIL PROTECTED]
> Hello Everyone:
>
> I have an '01 Town & Country Limited with 3.8L engine. I have a problem
with
> the rear power lift gate. It does not work properly. When I hit the
button
> to open. It beeps 3 times, lock unlocks, gear solenoid energizes and
motor
> will turn 1/4 turn then stop. Just bought vehicle so I don't know the
> history. Today I checked the voltage at the connector by the motor ( yes
I
> have cover off ) and found that the voltage goes to 12 volts momentarily
> then shuts off. Is their a limit switch in the closed position? I
checked
> the switch in the open position ( Good ). Someone said maybe dealer will
> have to set the stop position using diagnostic tool. Is this something I
can
> do? What about the little control board below the motor assembly? Any
help
> is appreciated.
>
> Thanks Larry
>
>
More then likely the liftgate latch is bad. The switch cant tell the
module
what position the door is in, Open or Closed so it just doesn't do
anything.
A scan tool would be needed to verify this.
Glenn Beasley
Chrysler Tech
