Re: Wram Motor Won't Start

maxpower wrote:

> You have a crankshaft position sensor fault, The sensor could be bad or
a
> number of other things from a shorted or open 5 volt supply from the PCM
.
> Crank signal open or shorted. Faulty ground and so on. If you just
wanted to
> take a pot shot at it, replace the crank sensor

Hope it's not like on my 1993 Nissan Altima.  The crank sensor was part 
of the distributor and had to be replaced along with it.  $500 for the 
distributor plus labor.  The distributor seal had leaked allowing oil 
into the sensor.  Where is the sensor in most late model Dodges or does 
it vary widely with different engines?