by cselby@[EMAIL PROTECTED]
Jan 6, 2008 at 12:10 AM
On Sat, 05 Jan 2008 04:11:31 -0500, gjm6syn6@[EMAIL PROTECTED]
wrote:
>I have good pressure to the sensor, which is located just below the
>lifter galley, but no oil coming through lifters and rods onto head.
>Anyone encountered this before?
>
Happens to some but usually not all lifters/pushrods.
Plugged lifters
Plugged oil gallery
Plugged push rods
Worn lifters (top end)
Worn push rods (both ends)
Worn rockers
I would go with the worn push rods and rockers before looking at the
lifters. A heavy dose of a engine flush in the oil to wash out the
crude is a good idea.
Pete
