by "ScottM" <no@[EMAIL PROTECTED]
>
May 7, 2008 at 10:30 PM
I think the car will run, and probably run ok but it probably won't inject
fuel at the right time....???? You better get one of these:
http://www.sjdiscounttools.com/otc6472.html
"komobu" <curranpg@[EMAIL PROTECTED]
> wrote in message
news:ed32ac73-23d0-41f9-9792-3807193169a9@[EMAIL PROTECTED]
>I am replacing the head gaskets on an 01 Taurus with a 3 liter engine.
> I pulled the camshaft synchronizer with out marking it correctly. I
> had the exterior marked, but not the internal. a fem minutes later, I
> put it right back in. I have not put the heads back on yet. I do not
> have the special tool for the camshaft synchronizer. I am probably at
> most one tooth off on the helical gear. Should I be concerned? Any
> advice on this would be helpful.
>
>
> Thanks
> Pat
