by Gyzmologist <ru-nuts@[EMAIL PROTECTED]
>
Apr 26, 2008 at 07:31 PM
Dom M wrote:
> I was wondering if anyone knows the exact setting for the TPS? I have a
> feeling I have it's set pretty close but not sure. The car is a 91
> Galant 2.0 FI. Thank You!
>
With the throttle closed adjust the TPS to obtain 0.5VDC between
terminals 2 & 4 (#1 is power, +5VDC). Be sure to use a digital ohm meter
to minimize the load and give the most accurate reading.
After setting the TPS move the throttle slowly from fully closed to
fully open and back to fully closed and verify that the voltage change
is smooth and without fluctuations. If there are fluctuations in the
voltage then the TPS should be replaced.
--
Gyz
Everyone thinks they know how to drive.
Everyone thinks they are good drivers.
