Re: Knock Sensor relocation ??

WildBill66 wrote:

> The knock sensor is bad on my Z-32 and I've read a couple of posts on
> another site that suggests relocating the sensor to a drivers side head
> bolt.
> http://twinturbo.net/net/viewmsg.aspx?forum=technical&msg_id=786419
> 
> Anyone ever done this or heard of it done without any issues.  The
author
> of the post does alot of engine work himself.  Also read a thread about
> jumping the sensor with a 1 meg-ohm resistor which reads like a bad idea
=
> no protection and kind of a mickey mouse approach.
> 
> Also read that the wiring sub harness sometimes will have wire breaks or
> corrosion.  Gonna get a new harness regardless, so that's one option.
> 

I just bolt them to the rear most intake manifold bolt that holds the
upper/lower intake together and tell people USE PREMIUM FUEL!!! It won't
be
an issue if you use good gas.


> Also considered dropping the 5speed tranny and reaching the sensor that
> way.

Good luck! I have no idea how you'd get it from that direction.. It's
UNDER
the lower intake manifold. You can't replace it with the engine out of the
car without removing both manifolds.

> 
> 10 hours of work or a short cut, any advice would be appreciated. 

It's way more than 10 hours worth of work even if you've done it before!
The
only reason to go there is if the engine also has leaking valve covers or
needs injectors, the EGR tubes cleaned out etc.
-- 
 
 Steve

http://www.atlantaracing.com