All,
This past summer my water pump leaked so I replaced my water pump and
thermostat. My temp gauge barely got past the Cold mark setting. After
driving for several miles, it moved up close to half mark. I went
ahead and replaced the thermostat again, thinking it was bad. Same
results. Checked fluid and was good, hoses upper/lower where nice and
hot. Everything seemed ok. Faulty gauge????
This morning it was very cold. No hot air. The gauge is still only
going over a bit over the Cold mark and the air is not freezing, but
it is not even warm.
I have seen a lot posts, but I wanted to see if you could send me some
tips on what to check as possible sources of my heating problem.
Thanks
ER
