From what I remember the main difference in the standard Peugeot iso and
the
adaptor connecter was to do with the powering of it off with the key and
the
dimming side of it when the lights were switched on. I think there are 2
wires that you can switch in the ISO to make the radio dim when the lights
are on.
Unfortunately I cannot remember which ones the were or what the part
number
was I had..
The stalk controls worked ok with the adaptor and the Sony cd player.
To be honest ,the times I belt the stalk control with my knee when I get
in
and out I am surprised it still works, not the greatest of designs is it.
In the end though I got fed up with the 406 centre display only showing
the
time and I much preferred the original look to the dash, so I purchased a
used Peugeot 406 cd player via ebay and fitted that instead. All I needed
to
do was take the car to a Peugeot dealer and have the new cd programmed to
the car, cost me £40 for the radio and £15 to get it programmed. Plus all
the controls and the centre display work as they should. You can even get
an
adaptor so you can plug an MP3 player into the system as well.
GGJ
"spectrum" <spectrumav@[EMAIL PROTECTED]
> wrote in message
news:KKNgj.5019$O01.3145@[EMAIL PROTECTED]
> Thanks Gary.
> I have installed a jvc stereo,the problem is the dimmer function and the
> stalk control.The standard fitting does work,but i was unsure if perhaps
> some supply wiring was different,causing the stalk interface not to
work.
> I assume there is some wiring difference or there would be no need for a
> Peugeot to Standard ISO adapter that many places sell,it is a PC2-74-4.
>
>
> Mark
>
> "Gary G Jones" <ggjggjnospam@[EMAIL PROTECTED]
> wrote in message
> news:luOdnb5vBoUGPh7anZ2dnUVZ8qydnZ2d@[EMAIL PROTECTED]
>> The wiring on my 406 was "standard", When I fitted a Sony cd to the
car
>> I purchased one of those ISO adaptors I think that's what they call
them,
>> "Peugeot to a Sony" adaptor.
>> Is it a Sony radio you are trying to fit by any chance, I think as long
>> as the radio has the Sony jack socket fitted at the rear it should
work.
>> GGJ
>>
>>
>> "spectrum" <spectrumav@[EMAIL PROTECTED]
> wrote in message
>> news:tyHgj.8355$a61.692@[EMAIL PROTECTED]
>>> Thanks Keith but it was me who made the radio stalk post.
>>> My question was ,is the wiring 100% standard as it may be that which
is
>>> causing the stalk remote not to work.
>>>
>>> Mark
>>>
>>> "spectrum" <spectrumav@[EMAIL PROTECTED]
> wrote in message
>>> news:8%lgj.28918$KC3.26697@[EMAIL PROTECTED]
>>>>I have just installed a new radio and was told that the ISO wiring was
>>>>standard and did not require any adaptation.But looking around I see
>>>>that there are wiring adapters.I ask because i can not get the stalk
>>>>interface to work.
>>>>
>>>> Any advise.
>>>>
>>>> Mark
>>>>
>>>
>>>
>>
>>
>
>
|
