On May 3, 5:43=A0pm, "Keith W" <invalidaddr...@[EMAIL PROTECTED]
>
wrote:
> "species8350" <not_here.5.species8...@[EMAIL PROTECTED]
> wrote in message
>
>
news:59d7f68b-4639-4eed-9d6c-6d8a752e8639@[EMAIL PROTECTED]
> On May 3, 3:40 pm, Chris <ch...@[EMAIL PROTECTED]
> wrote:
>
> > Have the disrtibutor looked at it be wear in the shaft which ahs the
> > rotor arm at the end of it, if that shaft is worn you can get all sort
> > of problems, one way to find out if it is worn remove the cap and try
> > and move the shaft side to side if it moves from side to side you got
> > problems,when was it serviced? like replace plugs,leads,cap. oil
> > etc.the coil might be sparking across to something metal try moving it
> > away from metal,
> >Thanks for the response.
> >On an =A080,000 ml Pug, I expect there will be wear.
> >could this cause oil contamination?
>
> Oil is more likely to be from somewhere else. =A0 A favourite is the oil
> pressure switch, another is the engine top cover gasket. =A0 In your
origi=
nal
> thread you mentioned the dipstick. =A0 In a recent query on this group
som=
eone
> had a blocked engine breather which caused internal pressure and forced
oi=
l
> out of the dipstick hole.
> --
> Keith Willcocks
> (If you can't laugh at life, it ain't worth living)
Yes,
I had this very same problem. Some oil was passing the top of the
dipstick.
I wonder if this could be causing electrical problems around the
distributor?
Thanks
|
