by "William Noble" <nobody@[EMAIL PROTECTED]
>
Nov 12, 2007 at 10:35 PM
start by putting power to the motor to make sure that it really isn't the
motor.
I have had this problem due to intermittant connections due to oxidized
copper in the central electronics - wiggle everything there with blower
selected on - it may start running
to check relay, use an ohmeter and clip leads - to check ballast
resistors,
use ohmmeter.
If motor runs when powered, then just trace the circuit backwards - the
schematic is in the service manual
<sjpatejak@[EMAIL PROTECTED]
> wrote in message
news:1194931956.286549.229440@[EMAIL PROTECTED]
> The ventilation blower on my '86 944T suddenly stopped working. I'm
> assuming that this isn't the motor itself, because it gave no previous
> problems. It isn't the fuse. That leaves the relay and the ballast
> resistor. How do I check these to see if they are bad? Thanks in
> advance.
>
--
Posted via a free Usenet account from http://www.teranews.com
