Re: removing headlamp mechanism

Hello someone,

Thank you for your advice,

I wondered how to get the shaft through the bearing. There is a fixture on
the shaft end with which to connect to the motor drive shaft in the engine
compartment. That bit can't go through the bearing obviously. How to do
that? I thought the lamp assembly had to come off the shaft before sliding
on the bearing.

Ad
<someone@[EMAIL PROTECTED]
> schreef in bericht
news:44E3D22C.2080003@[EMAIL PROTECTED]
>
> That could be the case. I've had the whole front apart and I'm not
> picturing how to do it otherwise. It needs to be on from the outside
> before inserting the long rod from the headlamp bucket.
>
> Sorry.
>
> Ad wrote:
> > I have a broken bearing of the headlamp axis. It is mounted in the
inside of
> > the wheelarch. It is however possible to remove the two bolts that
fixes
the
> > assembly to the inner fender. I can't see how I can remove the
headlamp
> > assembly in order to put in the newe bearing. Do I need to remove the
> > fender?
> >
> >