Re: removing headlamp mechanism

I was wondering about that as well.

I don't recall how the get the headlight bucket off the shaft. Actually 
don't think it does, but then how does the bearing get on?

If you're still stuck, post this weekend and I'll look around my garage 
for one. I think one is out there. Somewhere.

Ad wrote:

> Hello someone,
> 
> Thank you for your advice,
> 
> I wondered how to get the shaft through the bearing. There is a fixture
on
> the shaft end with which to connect to the motor drive shaft in the
engine
> compartment. That bit can't go through the bearing obviously. How to do
> that? I thought the lamp assembly had to come off the shaft before
sliding
> on the bearing.
> 
> Ad
> <someone@[EMAIL PROTECTED]
> schreef in bericht
> news:44E3D22C.2080003@[EMAIL PROTECTED]
> 
>>That could be the case. I've had the whole front apart and I'm not
>>picturing how to do it otherwise. It needs to be on from the outside
>>before inserting the long rod from the headlamp bucket.
>>
>>Sorry.
>>
>>Ad wrote:
>>
>>>I have a broken bearing of the headlamp axis. It is mounted in the
> 
> inside of
> 
>>>the wheelarch. It is however possible to remove the two bolts that
fixes
> 
> the
> 
>>>assembly to the inner fender. I can't see how I can remove the headlamp
>>>assembly in order to put in the newe bearing. Do I need to remove the
>>>fender?
>>>
>>>
> 
> 
>