Re: removing headlamp mechanism

Well, I found out. It appears that the headlamp is secured by two pins that
run through the lamp and the axis. Now I have to find out if these pins
can
be removed from the assembly....

Anyway, thanks a lot.

Ad

<someone@[EMAIL PROTECTED]
> schreef in bericht
news:_zaFg.7309$Qf.1969@[EMAIL PROTECTED]
>
> I was wondering about that as well.
>
> I don't recall how the get the headlight bucket off the shaft. Actually
> don't think it does, but then how does the bearing get on?
>
> If you're still stuck, post this weekend and I'll look around my garage
> for one. I think one is out there. Somewhere.
>
> Ad wrote:
>
> > Hello someone,
> >
> > Thank you for your advice,
> >
> > I wondered how to get the shaft through the bearing. There is a
fixture
on
> > the shaft end with which to connect to the motor drive shaft in the
engine
> > compartment. That bit can't go through the bearing obviously. How to
do
> > that? I thought the lamp assembly had to come off the shaft before
sliding
> > on the bearing.
> >
> > Ad
> > <someone@[EMAIL PROTECTED]
> schreef in bericht
> > news:44E3D22C.2080003@[EMAIL PROTECTED]
> >
> >>That could be the case. I've had the whole front apart and I'm not
> >>picturing how to do it otherwise. It needs to be on from the outside
> >>before inserting the long rod from the headlamp bucket.
> >>
> >>Sorry.
> >>
> >>Ad wrote:
> >>
> >>>I have a broken bearing of the headlamp axis. It is mounted in the
> >
> > inside of
> >
> >>>the wheelarch. It is however possible to remove the two bolts that
fixes
> >
> > the
> >
> >>>assembly to the inner fender. I can't see how I can remove the
headlamp
> >>>assembly in order to put in the newe bearing. Do I need to remove the
> >>>fender?
> >>>
> >>>
> >
> >
> >