Yep. Just was looking at a salvaged part. Two rolled pins hold the
latching arm to the shaft. The headlight bucket slides around the shaft
when it's not latched down.
Anyways, looks like a tough one to get. If you can get those two pins
out, and remove the center section of the lifting bar, you'll be able to
get that bearing in. Hope that doesn't mean taking the fender off. Not
easy getting the bolts into the firewall or into the bumper cover off.
Best of luck.
Ad wrote:
> Well, I found out. It appears that the headlamp is secured by two pins
that
> run through the lamp and the axis. Now I have to find out if these pins
can
> be removed from the assembly....
>
> Anyway, thanks a lot.
>
> Ad
>
> <someone@[EMAIL PROTECTED]
> schreef in bericht
> news:_zaFg.7309$Qf.1969@[EMAIL PROTECTED]
>
>>I was wondering about that as well.
>>
>>I don't recall how the get the headlight bucket off the shaft. Actually
>>don't think it does, but then how does the bearing get on?
>>
>>If you're still stuck, post this weekend and I'll look around my garage
>>for one. I think one is out there. Somewhere.
>>
>>Ad wrote:
>>
>>
>>>Hello someone,
>>>
>>>Thank you for your advice,
>>>
>>>I wondered how to get the shaft through the bearing. There is a fixture
>
> on
>
>>>the shaft end with which to connect to the motor drive shaft in the
>
> engine
>
>>>compartment. That bit can't go through the bearing obviously. How to do
>>>that? I thought the lamp assembly had to come off the shaft before
>
> sliding
>
>>>on the bearing.
>>>
>>>Ad
>>><someone@[EMAIL PROTECTED]
> schreef in bericht
>>>news:44E3D22C.2080003@[EMAIL PROTECTED]
>>>
>>>
>>>>That could be the case. I've had the whole front apart and I'm not
>>>>picturing how to do it otherwise. It needs to be on from the outside
>>>>before inserting the long rod from the headlamp bucket.
>>>>
>>>>Sorry.
>>>>
>>>>Ad wrote:
>>>>
>>>>
>>>>>I have a broken bearing of the headlamp axis. It is mounted in the
>>>
>>>inside of
>>>
>>>
>>>>>the wheelarch. It is however possible to remove the two bolts that
>
> fixes
>
>>>the
>>>
>>>
>>>>>assembly to the inner fender. I can't see how I can remove the
headlamp
>>>>>assembly in order to put in the newe bearing. Do I need to remove the
>>>>>fender?
>>>>>
>>>>>
>>>
>>>
>>>
>
>
|
