The squealing and a screaming has got to to stop! My non working clutch
started working again and has been ok for the last couple of months -
except, of course, the sound of the death throes of the release bearing.
Now, can I change the release bearing without removing the clutch? If I
were to pull the splined shaft, push the slave cylinder in a bit and pull
and replace the release bearing.
It's a banger - I'm not going to spending spending GBP100+ (USD200) on
new plates for a car I only paid GBP 250 for if I don't have to and if I
don't have to remove the clutch so much the better.
--
Simon
