Re: Strange Clutch Problem

On Feb 25, 9:39=A0am, keith_kichef...@[EMAIL PROTECTED]
 wrote:
> You may eventually need to remove the bell housing, to see if the
> spline has stripped where the two uprights (holding the throwout
> bearing) attach to the round shaft. =A0This is a common failure, usually
> more so, with a pressure plate with heavy springs. =A0Once repositioned,
> it can be welded.

Hi All, hanks for your input.  I am going to be positive and go with
checking the clevis pins First.  It seems to me that if the splines
were stripped or stripping, you would feel it suddenly giving as it
jumped from one plie to the next, so to speak.  But it gives me
directions any way!
-George-
-59 Lark
-63 GT Hawk
-63 Champ