It is a 259 with a new edlebrock 500 cfm carb and a 3 speed on the column.
I
have a floor ****ft that I bought for it but never installed. I am about 30
miles north of Charlotte, NC by way of interstate 85. I had big plans for
this car but have lost interest. There are a lot of NOS stuff in the
trunk.
All new weatherstriping for the doors and trunk. A new trunk mat and other
new rubber parts. I also have another 259 engine with r1 heads that I was
planning on rebuilding with loads of performance parts from Phil Harris.
It
includes cam, R3 headers, R3 intake valves, aluminum timing gear,new valve
springs and resurfaced lifters. I also have a Chevy pattern t10 4 speed
with
bell housing and a 331 tt model 44 rear axle. I am going to put together a
list of all the parts I have and will sell everything I have. If someone
wants the car and all the parts I will make them a super deal.
Thanks for your interest,
Henry
--
Henry
"The Other Dave" <thehouseinspector@[EMAIL PROTECTED]
> wrote in message
news:fsecp5013te@[EMAIL PROTECTED]
> Henry-
>
> What engine/tranny? Where are you located?
> "blacklarkviii carolina.rr.com>" <hwalterjr@[EMAIL PROTECTED]
> wrote in
message
> news:47e8599f$0$12544$4c368faf@[EMAIL PROTECTED]
>> Hey guys I am going to sell all my Studebaker stuff in the next little
>> while. I am starting with my 63 lark 2 door post. It has some rust in
the
>> front floorboards and front fenders. It has been fixed before but
really
>> needs to be cut out and redone. Interior is fair with bucket seats and
a
>> console. I have replaced the 63 dash with a 64 dash. I installed a tach
>> in the center hole in the dash where the clock was. It aslo has a brand
>> new set of chevy disc brake calipers with Plymouth Trailblzer rotors.
All
>> the steel brake lines have been replaced with new computer bent ss
lines.
>> I would like to get $2500 for this car, but would consider offers. If
no
>> one buys it here I will put on e-bay.
>> Thanks,
>> Henry
>>
>
>
|
