Dave,
Thanks for your help, this method works like a charm.
Best regards,
Paul.
"Dave Grebe" <DGrebe@[EMAIL PROTECTED]
> wrote in message
news:3F47AC84.D0A7B0E6@[EMAIL PROTECTED]
> Try this link, found via Google:
>
> http://groups.yahoo.com/group/probe-perf/message/25394?source=1
>
> >The TBS terminal of the diagnostic plug is the ABS-computer's
equivalent
of
> >the PCMEs TEN pin.
>
> The diagnostic plug is under the hood near the battery and fuse box.
Jumper
> TBS to GND (I used a small paper clip).
>
> >If the TBS pin is grounded and the ignition is switched on, I think the
ABS
> >light will flash codes (if there's any) exactly as the check engine
light
does.
>
> The long flashes are the first number and the short flashes are the
second.
> For example one long and 3 shorts = 13.
>
> >Maybe the original poster can try this and let us know what codes he
sees
> >and we'll try to get an answer for him. A simplified list of codes:
> >
> >11 RF speed sensor or rotor
> >12 LF speed sensor or rotor
> >13 RR speed sensor or rotor
> >14 LR speed sensor or rotor
> >15 speed sensor (ABS unit bad)
> >22 hydraulic harness unit
> >51 fail safe relay
> >53 motor or motor relay
> >61 control unit
> >
> >
> >
> >You can also erase codes. Get this...let all the codes be displayed.
Then,
> >after the first code is displayed, tap the brake pedal 10 times at a
rate
of
> >more than once per second (i.e. tap the pedal 10 times in less than 10
> >seconds) and the codes will be erased.
> >
>
> Mine fixed themselves after I did a rear brake job, look for other
> problems first. Also try cleaning the sensors, they have a magnet
> int then and all kinds of metallic crap tends to stick to them.. The
> rear sensors are behind the brake rotors. The sensors are expensive
> so you won't want to change them if you don't have to.
>
> Hope this helps,
> Dave
>
> Disclaimer- I am not a mechanic.
>
> "Paul S." wrote:
>
> > Hello Everybody,
> >
> > Just recently after Mazda service replaced my clutch I started to
experience
> > ABS problems. Occasionally ABS light will come on and stay on until I
> > restart the car. Also I noticed that sometimes ABS will kick in even
when I
> > break normally. Anybody knows how can I troubleshoot this problem and
check
> > the fault codes? Is it possible to check ABS codes on this model and
where
> > can I find them?
> >
> > Thanks Paul.
>
|
