Re: UJ's ... again !!!

"Ian Rawlings" <news06@[EMAIL PROTECTED]
> wrote in message
news:slrng77hv9.9bu.news06@[EMAIL PROTECTED]
> On 2008-07-08, Dougal <Dougal@[EMAIL PROTECTED]
> wrote:
>
> > This is a phasing issue to make the best of an imperfect
> > installation - the equal angle criterion mentioned above is not met.
> > It's not to avoid a clearance problem at high angles.
>
> According to the landrover workshop manual;
>
> "The phasing is necessary on the front shaft only to allow for greater
> variation in angular changes".
>
> So, that clears up nothing then ;-)
>
 And there's nothing clearer :-)