by "6string" <6stringa440@[EMAIL PROTECTED]
>
Mar 8, 2007 at 10:51 PM
Hi Juha, You are talking about the metal strip along the outside bottom
edge of the door?
If I remember right they are held in place by large clips. Personally, I
think I'd remove the door panel and push the clips out from the inside.
When
the car was new the clips were fairly pliable but over the years they've
gotten stiff and now you are more likely to damage the trim by trying to
pry
them loose from the outside.
Hope this helps, Jon
"Juha Telen" <jtelen@[EMAIL PROTECTED]
> wrote in message
news:espm04$tq6$1@[EMAIL PROTECTED]
> Hi, what is the best method of removing door moulding of a 1967
Satellite,
> without damaging the painwork or the moulding?
>
> Thanks Juha
