Re: How difficult is it replacing turn signal switch harness - e-body?

You need to pull the harness 'up the column' actually.
It's not too difficult a job, but you'll need a little patience.
The connector at the bottom will likely need all the wires removed from
it.
So you'll need a pin (or blade) removal tool, which Radio Shack should
have.
Make sure you map out the wires in that pin connector so you can get them 
all back in the right order.
Seems to me the only other tricky parts are steering wheel removal, and 
you'll need a circlip tool for the top bearing.

Good Luck, Lefty

"asdf" <asdf@[EMAIL PROTECTED]
> wrote in message 
news:UvGdnYigeY1JItLbnZ2dnUVZ_gidnZ2d@[EMAIL PROTECTED]
> I've taken the steering wheel off and their are several broken plastic 
> parts including the horn contact.
>
> How hard is it to put a new harness down the column?  Anyone?
>
> '71 Cuda owner
>
>