When you pull the harness up, tape a string to it, to help with the
install on the new one.
Lefty wrote:
> You need to pull the harness 'up the column' actually.
> It's not too difficult a job, but you'll need a little patience.
> The connector at the bottom will likely need all the wires removed from
it.
> So you'll need a pin (or blade) removal tool, which Radio Shack should
have.
> Make sure you map out the wires in that pin connector so you can get
them
> all back in the right order.
> Seems to me the only other tricky parts are steering wheel removal, and
> you'll need a circlip tool for the top bearing.
>
> Good Luck, Lefty
>
> "asdf" <asdf@[EMAIL PROTECTED]
> wrote in message
> news:UvGdnYigeY1JItLbnZ2dnUVZ_gidnZ2d@[EMAIL PROTECTED]
>
>>I've taken the steering wheel off and their are several broken plastic
>>parts including the horn contact.
>>
>>How hard is it to put a new harness down the column? Anyone?
>>
>>'71 Cuda owner
>>
>>
>
>
>
|
