by "John Kunkel" <nobody@[EMAIL PROTECTED]
>
Jan 31, 2008 at 11:59 AM
"Rich Jordan" <jordan@[EMAIL PROTECTED]
> wrote in message
news:8635e778-1623-47a7-9636-f0295411cae6@[EMAIL PROTECTED]
> Does anyone make a jig for benchtop work on a Chrysler center
> section? Looking for something the pig will attach to/bolt on to that
> can be either clamped in a vise or attached to a bench so it holds
> still while being worked on.
A couple of pieces of heavy angle iron can be drilled to mount the pig in
a
universal engine stand or check out the link below for a heavier duty
setup:
http://bcwengineering.com/diff_repair_stand.htm
