Re: Jig for working on 8-3/4" center sections

On Jan 31, 1:59 pm, "John Kunkel" <nob...@[EMAIL PROTECTED]
> wrote:
> "Rich Jordan" <jor...@[EMAIL PROTECTED]
> wrote in message
>
> news:8635e778-1623-47a7-9636-f0295411cae6@[EMAIL PROTECTED]
>
> > Does anyone make a jig for benchtop work on a Chrysler center
> > section?  Looking for something the pig will attach to/bolt on to that
> > can be either clamped in a vise or attached to a bench so it holds
> > still while being worked on.
>
> A couple of pieces of heavy angle iron can be drilled to mount the pig
in a
> universal engine stand or check out the link below for a heavier duty
setup:
>
> http://bcwengineering.com/diff_repair_stand.htm

John,
     that stand looked pretty nice.  It does give me an idea of how to
use my own engine stand for the task too.  Thanks!

Rich