Mike Romain wrote:
> S. A wrote:
>> My '93 Cherokee S****t drivers side turn signal started fla****ng
extremely
>> fast all of a sudden. The passenger signal flashes correctly. A few
>> times after
>> starting the Jeep the drivers signal that flashed fast would just stay
on
>> permanent when used, then on next restart would flash fast again. I've
>> changed the flasher unit (2 tab unit) and still same problem. All bulbs
>> (brake & turn sig. headlight) working correctly (inside & out) and same
>> brightness.
>>
>> Also... oil pressure gauge is acting up, needle pegs when accelerating
>> and
>> fluctuates when driving. Haven't replaced sender yet, I assume this is
>> probably the problem?
>>
>> Any idea's where to look or fix for turn sig ?
>>
>> Thanks S.A
>>
>>
>>
>>
> The fast blink means a bulb has a bad connection (not enough power) or
> one is out.
>
> The oil sender connection sounds loose.
>
> If they are both connected, then I would look to the body ground strap.
> There should be a mesh cable running from the engine head to the
> firewall. These rot out causing lots of strange things to happen.
One other thing, when you removed the flasher was one leg rusty? If so,
the contact in the fuse panel needs a clean.
Also did you get the 'right' flasher? There are two of them. You can
just touch it when it is fla****ng to feel if it is the right one.
>
> Mike
> 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
> 'New' frame in the works for '08. Some Canadian Bush Trip and Build
> Photos: http://mikeromainjeeptrips.shutterfly.com
|
