"Kwyjibo" <kwyjibo@[EMAIL PROTECTED]
> wrote in message
news:pcqdnWybrcp4D7vVnZ2dnUVZ_vjinZ2d@[EMAIL PROTECTED]
>
> "Trevor Wilson" <trevor@[EMAIL PROTECTED]
> wrote in message
> news:68ngffF2u28orU1@[EMAIL PROTECTED]
>>I had to cut some 8mm steel yesterday and today. I dusted off my trusty
9"
>>angle grinder and set to work. I wore out one wheel (Flexovit)and the
only
>>one I had available was an 8" Flexovit (Aussie made). I wore it out in
>>short order. It's cutting performance was what I would term
>>"satisfactory". About 2cm/minute (best guess). I toddled off to Bunnings
>>this afternoon to buy some more wheels. Unfortunately, the Flexovit
wheels
>>had the wrong size mounting hole, so I purchased a 5 pack of Trojan
>>(Chinese made) branded wheels. Hopeless cutting performance. I mean,
>>REALLY BAD. It took about 5 minutes to cut 2cm. The wheel didn't wear
down
>>and faster or slower than the Flexovit. It just hardly cut the metal at
>>all.
>>
>> What gives?
>>
>> The technology is hardly state of the art. All wheels are rated for
>> ferrous metal cutting. Since most of my cutting is done with a 4"
>> grinder, this is not something I've experienced before. I've not
>> experienced this sort of poor performance when cutting concrete, bricks
>> and stone. Are all these Chinese wheels bad, or did I get a bad batch?
>
>
> Dunno, but for 8mm I probably wouldn't use an angle grinder in the first
> place. A wet saw is much better for that sort of work. Save the angle
> grinder for grinding, or cutting thinner steel - say up to 3mm.
**All very well, but I only have an angle grinder. Anyway, job done, but I
still want to know about any experiences with Trojan cut-off wheels.
Trevor Wilson
|
