by "Knobdoodle" <knobdoodle@[EMAIL PROTECTED]
>
May 11, 2008 at 12:07 PM
"Trevor Wilson" <trevor@[EMAIL PROTECTED]
> wrote in message
news:68njnbF2u518tU1@[EMAIL PROTECTED]
>
> "Sooky Michael" <mike@[EMAIL PROTECTED]
> wrote:
>> The 4 inch grinder with those super thin cutting wheels would do a lot
>> better than 2cm/minute.
>
> **I did use the 4" Bosch for a small cut. It took forever. 8mm steel
needs
> a lot more grunt than a 4" grinder. Still, I was only using the standard
> cut-off wheels. How thick are the "super thin" cutting wheels? I used
the
> 4: grinder to clean up the edges.
>
They'd be less than 1mm thick. 1/2mm maybe.
I've never tried them on anything thick though.
--
Knob
