by "Trevor Wilson" <trevor@[EMAIL PROTECTED]
>
May 12, 2008 at 07:00 AM
"Michael C" <mike@[EMAIL PROTECTED]
> wrote in message
news:4826f08e$0$30461$afc38c87@[EMAIL PROTECTED]
> "Trevor Wilson" <trevor@[EMAIL PROTECTED]
> wrote in message
> news:68njnbF2u518tU1@[EMAIL PROTECTED]
>> **I did use the 4" Bosch for a small cut. It took forever. 8mm steel
>> needs a lot more grunt than a 4" grinder. Still, I was only using the
>> standard cut-off wheels. How thick are the "super thin" cutting wheels?
>
> 1.22mm according to the verniers. You might find it cuts better as it's
> taking out a lot less material than the bigger grinder.
**Yeah, that makes sense. I'd be a little wary about using a disk as thin
as
that in a hand held grinder though.
Trevor Wilson
