abuckslife@[EMAIL PROTECTED]
wrote:
> Like many of these I have read before, my blower motor quit working
> and has 12V to the connector and I replaced the blower motor as a
> precaution. I have pulled off the dash and seen only one braded ground
> that went to directly to the radio. I could not locate any other
> ground wire. Can anyone tell me exactly where the right side panel
> ground is located?
> Regards,
> Mike
You are dealing with a Recall!
A Recall means the $tealer****p 'has' to fix it for FREE!
The 'two' groundstraps that are under recall are bolted to the back of
the instrument cluster, not the heater. This means the whole instrument
cluster has to come out to get at them.
I have also heard of the power plug to the heater burning out on the
harness side.
Recall 99V117000: Instrument Panel Ground Screws Loose
The left side and right side instrument panel wiring ground attachment
screws could loosen over time. If the left side screw loosens, the
instrument panel gauges may not function when the headlamps are turned
on. If the right side screw loosens, the defroster blower motor may
not function.
Dealers will remove the ground screws, drill a new pilot hole adjacent
to the original hole, and the screws will be reinstalled in the new
holes.
Owner notification began May 31, 1999. Owners who take their vehicles
to an authorized dealer on an agreed upon service date and do not
receive the free remedy within a reasonable time should contact
Chrysler at 1-800-992-1997. Also contact the National Highway Traffic
Safety Administration's Auto Safety Hotline at 1-888-DASH-2-DOT
(1-888-327-4236).
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
'New' frame in the works for '08. Some Canadian Bush Trip and Build
Photos: http://mikeromainjeeptrips.shutterfly.com
|
