Re: Need help identifying a black box.

....it turns out that the severe hesitation and erratic acceleration was
due
to a shorting out of a spark plug.  $40.00 repair and he is back on the
road.  I dodged a bullet this time!

----- Original Message ----- 
From: "Bill Putney" <bptn@[EMAIL PROTECTED]
>
Newsgroups: rec.autos.makers.Chrysler
Sent: Sunday, January 27, 2008 8:34 AM
Subject: Re: 2001 Chrysler Sebring


> Bob AZ wrote:
>>> No doubt the same input and output sensor failures that occasionally
>>> happen (at the rate of about one every 50 to 100k miles) on all the
>>> Chrysler electronic trannies. ?The sensors cost under $20 each and
take
>>> about 15 minutes to replace.
>>>
>>> Bill Putney
>>
>> Bill
>>
>> Does this apply to my Chrysler LHS?
>>
>> Bob  AZ
>
> Yes.
>
> Bill Putney
> (To reply by e-mail, replace the last letter of the alphabet in my
address 
> with the letter 'x')

"Daniel Who Wants to Know" <danielthechskid@[EMAIL PROTECTED]
> wrote in 
message news:lUbrj.22216$9j6.8688@[EMAIL PROTECTED]
>I stated that I would start a new thread about the 95 GC SE that I bought

>and here goes.  While inspecting the speakers in the liftgate (passenger 
>rear was dead, broken wire)  I noticed a black box/module of some sort 
>mounted near the bottom passenger corner (back passenger corner with the 
>liftgate open) with a melted spot on it.  The interior lights don't turn
on 
>when the liftgate is open and the rear washer/wiper is dead so I assume
it 
>has something to do with either of those 2 functions.  Upon removing the 
>PCB from said module I noticed that a transistor has had a very bad day
and 
>completely disintegrated taking a section of the PCB with it.  The module

>has 6 connector pins and the numbers on it are as follows (a google
search 
>on them turned up nothing).  Thanks
>
> Front:
>
> Chrysler pentastar logo
>       4661297
>       93596 A
>   Made in Canada
>                       1
>
> Rear:
>
>     34 34
>