Hi,
In an attempt not to spend £80 per hour at my main dealer i took my
intermittantly stalling 02 reg 2.5 CRD Grand Voyager Limited to my local
garage. I even threw in a copy of the Chrysler workshop manual in case
they
got stuck
They happily re****ted that it was error code P0340 and had replaced the
camshaft position sensor and all was well.
It was all ok if you class only being able to get 6 miles ok.
Anyway its back with them and they arent getting very far with it. I have
asked them to follow the workshop manual not the Bosch Autodata machine,
but
they dont seem convinced.
Has anyone had this issue before :
Driving is fine, then if youre lucky you get one slight judder, then a
minute later full engine cutout. If left for 15 to 20 minutes it will
start
again...if you havent been cranking it and the battery has died. If you
get
it started you have approximately 5 maybe 10 minutes before it will do it
again. Only code its throwing is the P0340 apparently.
Any ideas greatfully accepted, before i just drag its sorry ass to the
main
dealers.
Cheers in advance
G
