Hello all:
2000 GC with typical hard ****fter actuation from the column. Thought it
might be the cable, since it was rusty & was original ****ft cable. After
disconnecting the ****ft cable at the transmission, I tried to rotate the
shaft by hand, but could not move it at all. Thought vehicle weight on
parking sprag was binding it, so I rocked the van back & forth a little to
see if the shaft would loosen up, again no luck. Could the shaft be bound
up at the casing? Or is this a failure of the TRS at t6he bottom of the
shaft?
Any ideas, thoughts welcome.
Randy
