"Hawkeye65" <rtaddis65@[EMAIL PROTECTED]
> wrote in message
news:1202689342_11715@[EMAIL PROTECTED]
> Could someone tell me a good tool to use to cut the old door hinge pins
of
> a 1989 Mustang LX? I have a pair of "bolt cutters" but the nose is not
> long enough to fit between the door and the fender. It is a rolling
> restoration.
>
>
>
> Thanks,
> Ty Addison
Last time I did door hinge pins I jacked up the door to keep it from
sagging
down when then pin was removed. (jack it up just enough to take the weight
off the pins). then take a hammer and a pointy thing smaller than the pin
and drive out of the hinge. If yours has a cotter pin too take that out
first. Do one pin at a time. Put in a new one after removing the old one.
It takes about 10 minutes per door.
