"WindsorFox" <darkshado666@[EMAIL PROTECTED]
> wrote in message
news:fopvja$7m8$2@[EMAIL PROTECTED]
> Boris wrote:
>> "Hawkeye65" <rtaddis65@[EMAIL PROTECTED]
> wrote in message
>> news:1202689342_11715@[EMAIL PROTECTED]
>>> Could someone tell me a good tool to use to cut the old door hinge
pins
>>> of a 1989 Mustang LX? I have a pair of "bolt cutters" but the nose is
>>> not long enough to fit between the door and the fender. It is a
rolling
>>> restoration.
>>>
>>
>> I thought they had a carter pin through a hole at the bottom of the
hinge
>> pin, pull out the carter pin, then pull out the hinge pin.
>>
>> ??
>
> Carter pin?? Mine doesn't have those. Mine doesn't even have Cotter
pins
> in it.
>
1993 5.0 LX Coup,
top pin has a carter pin,
bottom pin does not.
looks like the bottom pin is press fit, or screwed together(probably not
screwed)
A shop rehung both doors, I could not figure out how to remove the bottom
pin. not sure how they did it.
Could have ground the top off the bottom pin(?).
On my car both doors the top pins lost the carters and were floating up,
bu****ngs were worn, loose door, not good when going fast, squeeks too much
Good luck!
+ go Fast!
|
