Re: Tail light louvers PING: Dwight

Joe wrote:
> "WindsorFox<SS>" <darkshado666@[EMAIL PROTECTED]
> wrote in
> news:fvts92$hhc$1@[EMAIL PROTECTED]
 
> 
>> elaich wrote:
>>> Joe <party@[EMAIL PROTECTED]
> wrote in news:Xns9A97A511B4D7nospamforme@[EMAIL PROTECTED]
>>> 216.77.188.18:
>>>
>>>> Where do you come up with this crap?
>>> The original louvers were actual metal louvers that covered the
>>> entire rear lighting from side to side. The ones referred to on ebay
>>> were molded into the lens assembly, so you do not get the same effect
>>> as the metal louvers. 
>>>
>>     I've never seen a set with metal louvers that screw or stick over 
>> the plastic lens. Every pair that I've ever seen (and looked at close 
>> enough to notice) was molded into the plastic lens and then painted
>> the color of the car in the same way that the lines between the
>> segments on the LX lenses are painted black. I note this as I hold in
>> my hands the original OEM lenses off of a 90 GT and from my 89 LX
>> along with a new OEM replacement set for my LX. The post you quoted is
>> just more of that troll's petty bull**** that he posts in reply to any
>> post I make even if he's wrong, like now.
>>
>>    I have a representative photo showing said detail if you would like
>> to see it. If you have a photo of one with separate louvers I'd like
>> to see it. I'm sure it's possible the early GTs from 87 and 88 could
>> have been different.
>>
>>    Perhaps Dwight will be so kind as to tell us how the lenses are
>>    made 
>> on CFrog...
> 
> No matter how you cut it, they're not "painted onto the plastic lens" as

> WF erroneously claims (no surprise there).

    Absolutely 10,000% incorrect. This gibberish bull**** could not be 
more incorrect if this petty troll tried to be wrong by lying. This 
troll is purposely combative for no apparent reason and just attempts to 
invalidate a reply from me out of petty bull****. I know factually how 
these are made as I have a pair of lenses that I personally removed from 
a 1990 GT in a junkyard. They are the OEM Ford lenses and I have a 
picture that shows how they are made.

    The cheese grater look is molded into the plastic lens and is 
painted directly onto the plastic the same color as the car. So yes, the 
louvered look *is* painted on to the lens. I suggest the OP take that 
info to the bank from the person holding the lenses in his hand rather 
than a purposely combative troll. I have been told that the GT lenses 
can be placed on the LX tail light assy in replacement of the LX lenses, 
but I have never confirmed this myself.



"I've also noted that a couple of my regular spammers
have pretty much switched over to phi****ng and 419s
from pecker pills and sawdust tablets."   -   Bar0

"If it's from BRNIC, it's GOT to be blocked" - Buss Error