On 11 mar, 15:35, Mike Romain <roma...@[EMAIL PROTECTED]
> wrote:
> nrs wrote:
> > I recently had a starter rebuilt and now that it is installed, it does
> > not work very well. =A0It did not have any ****ms originally and it was
> > re-installed the same way. Sometimes it does not engage the flywheel
> > and when it does, it makes rumbling sounds. =A0Also, it makes a
scraping=
> > sound sometimes, both when it fails to engage and sometimes when it
> > does engage. =A0What could cause it to make scraping sounds? =A0Thanks
i=
n
> > advance.
>
> That sounds like the bu****ng in the nose didn't get replaced or you were
> too late and your flywheel ring gear is ground down...
>
> You need to pull the starter to see if it's the bu****ng or gear.
>
> A bad connection on the main cables going to the starter can also not
> pass enough power to kick it into the flywheel ring gear.
>
> Mike
> 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
> 'New' frame in the works for '08. =A0Some Canadian Bush Trip and Build
> Photos:http://mikeromainjeeptrips.shutterfly.com
The flywheel is fine. The starter failed by not turning and up until
then it worked perfectly so there was no chance to mess it up. The
nose bu****ng sounds dead on because I noticed it was not replaced,
figured they found it was in spec and they didn't see the need to
change it. That just might be the problem. Thanks a lot.
|
